PROCESS EXPERTISE

 

The topside facilities are also interrelated to flow assurance system analysis, and their requirements and capabilities must not be overlooked regardless of whether it is a front-end design or just a tie-back. This includes the capacity, arrangement, and control of all receiving equipment. Fluids reception and separation may consist of separators, slug-catchers, surge tanks, and flare knockout drums. The highest steady-state oil and water fluids rates are important for separator design. Arriving slug volumes during pigging operation are also important data for topside arrangement. Inputs on the capacity of chemical storage, injection and pumping through umbilicals are needed from flow assurance engineers.

Under the guidance of the client and project manager, instrumentation, controls, and facility capabilities must be completely integrated into the overall system design and operability. Timely interfaces of our process consultants with other design engineers and the client are essential for the project success.

Unlimited Flow Solutions process engineers consultants have more than 16+ years of world wide experience per individual offering both dynamic and steady state process simulation consultancy and advice. Addition of value to your project will come directly from our development and application of our dynamic simulation techniques combined with extensive process engineering knowledge to provide practical solutions to your engineering challenges.

From feasibility studies, pre-FEED, FEED, and following to detail design validation our process simulation knowledge and expertise provides our clients technical assurance throughout the value chain. Our services include the following process challenges:

 

 

PROCESS CHALLENGES

  • Separation
  • Gas dehydration
  • Sour gas sweetening
  • Gas treating
  • Gas compression
  • Oil treating
  • Pump stations
  • Oil and gas metering
  • Water treating
  • Storage facilities

SERVICES OFFERED

  • Feasibility studies
  • Conceptual design
  • Field optimization and de-bottlenecking
  • FEED
  • Cost estimating
  • Project management
  • Operational trouble shooting
  • Start-up and commissioning


We can, for example, work comfortably with the clients Reservoir/Production Engineers on the one hand and also with our topsides and onshore Process and Facilities Engineers and the contractor’s Construction Engineers on the other to bring this project to successful realization.

 

Pin It on Pinterest

Share This